Carbon epoxy plates

Continous fibre reinforced carbon epoxy semi-finished sheets offer high stiffness and strength with low weight. Haufler Composites produces CFRP plates that are used in demanding applications. These range from mechanical engineering, measurement technology and medical technology to sports equipment. We manufacture both solid carbon sheets and sandwich panels. They range in size from small plates to plates that are several metres long.

At Haufler Composites, CFRP boards are completely manufactured in our own production facility. This guarantees a semi-finished product that can be perfectly tailored to the end product. Depending on technical requirements, we can adjust fibre type and orientation, as well as the matrix systems.

At Haufler Composites, CFRP plates are manufactured entirely in-house. This results in a semi-finished product that can be optimally matched to the end product. Depending on the technical requirements, both the fibre types and fibre orientations as well as the matrix systems can be adapted.

High precision is required for mechanical engineering and industrial uses. CFRP sheets are also produced in a ground finish with tight thickness tolerances for such uses. By using high-modulus fibres, we are able to produce CFRP sheets with an elasticity modulus that is higher than that of steel on unidirectional sheets in the direction of the fibre.

Carbon plates can be machined conventionally by water jet cutting or milling.

For design applications that demand a superior surface finish, the surface variants “Matt”, “Textured” and “Gloss” are produced using a special press method.

Short delivery times even for project-specific semi-finished products thanks to full in-house production
Tight tolerances due to ground surfaces from 1 mm thick
Freely selectable fibre orientation (unidirectional, bidirectional, multidirectional)
Also available using high-modulus fibres
Finishes: “Gloss”, “Matt”, “Textured”
Rough surface on both sides (protected by peel ply) from 0.3 mm thick

Our CF/epoxy semi-finished products with multiaxial fibre orientation offer ideal options for introducing loads into fibre composite components.

Available as a semi-finished plate or as a CNC milled component.

For aerospace applications with an inspection certificate to DIN EN 10204 3.1.

CFRP inserts for fibre composite components

For visible applications where the highest demands are placed on the appearance of the carbon plates.

Our carbon veneer uses design-grade carbon fabric with minimal distortion and a closed thread pattern.

The matrix system is highly transparent and UV stabilised.

The visible face has a high-gloss finish, while the reverse has a ground surface ideally prepared for bonding.

Available in a 3K twill weave in sizes 123 cm x 98 cm and 193 cm x 98 cm, each 0.5 mm thick.

Further dimensions, weave patterns and yarn counts on request.

CFRP inserts for fibre composite components

Carbon veneer

Our carbon veneer is used in applications where the highest demands are placed on the optical appearance of the carbon plates.

In our carbon veneer, carbon fabric in design quality with minimal distortion and a closed weave pattern is used.

The matrix system is highly transparent and UV-stabilised.

The front side has a high-gloss finish; with its ground surface, the back side is optimally prepared for bonding.

Available in weave pattern 3K twill in dimensions 123cm x 98cm and 193cm x 98cm, thickness each 0.5mm.

Further dimensions, weave patterns and yarn counts on request.